Browsing by Subject "Hydraulic Pump"

Now showing 1 - 1 of 1
  • Thumbnail Image
    Item
    Modeling, Analysis, and Experimental Investigation of a Variable Displacement Linkage Pump
    (2015-07) Wilhelm, Shawn
    Hydraulic power systems offer a robust, compact, and flexible method of power transmission and are used widely in both industrial and mobile applications. While 2% of the energy consumed in the US passes through hydraulic systems, less than half of it does any useful work largely due to the use of inefficient flow control valves. Variable displacement pumps offer a method of delivering the required flow to an actuator without suffering the losses associated with a flow control valve. However, current variable displacement pumps exhibit poor efficiency at low displacement because their primary sources of energy loss are largely independent of displacement. Here, a novel adjustable linkage is proposed as the driving mechanism of a variable displacement pump. The linkage is constructed such that the pumping piston returns to the same top-dead-center position at all displacement, and can also achieve zero displacement. As a result of these features, the pump displacement is infinitely variable, and the unswept volume is remains constant at all displacements. By using pinned joints rather than sliding joints, the majority of the energy losses scale with output power resulting in a pump that is efficient over a wide range of operating conditions. In this thesis, a complete model of a variable displacement linkage pump is developed. A method of constructing the adjustable sixbar mechanism and the possible embodiments is presented. A new solution rectification technique is developed providing a robust method of generating valid linkages that is generally applicable to other mechanisms. The kinematics of the mechanism are then presented to describe the motion of the links and output piston. A kinetostatic model of the mechanism provides a means of determining the internal mechanical energy losses. A non-linear model of the bearing friction augments the model, but requires numerical methods to solve, and increases computational complexity. A dynamic model of the pumping cylinders and pump manifold provide a means of determining the fluid behavior of the pump including output flowrates and pressures. These models are coupled to create a complete understanding of the variable displacement linkage pump. The model is designed to be predictive and computationally inexpensive for use in multi-objective optimizations. As such, no experimentally determined performance coefficients are required. No model of this level of completeness exist for linkage driven pumps, variable displacement or otherwise. Two prototype pumps are presented and used to validate the models. A single cylinder pump is used to validate the mechanical energy loss model but was limited to low pressure operation due to large torque variations. Close agreement is demonstrated between the model and experiment. The model predicts a pump efficiency greater than 90% at displacements as low as 15% if roller bearings are used in the pin joints. To validate this prediction, a multi-cylinder prototype which uses roller bearings in the joints is designed. The kinematic and mechanical energy loss models are coupled to a basic pumping model for use in a multi-objective genetic algorithm to optimize the mechanism. The resulting pump demonstrates close agreement between the model and experimentally measured shaft torque and mechanical energy loss at various pressures, displacements, and input shaft speeds. However, out-of-plane deflection of the mechanism reduced the piston displacement and altered the trajectory reducing pump output. The true temporal piston position is measured and used as an input to the dynamic fluid model. The predicted and experimentally measured cylinder pressures demonstrate the effectiveness of the model at predicting the dynamic behavior of the fluid end of the pump. It is shown that the models can accurately capture the physics of the pump without using tuning parameters or experimentally determined coefficients over a wide range of operating conditions. It is recommended that single shear linkage arrangements are avoided in future designs to increase the mechanism stiffness and improve performance. The variable displacement linkage pump offers the opportunity for high efficiency flow control at a wide range of operating conditions due to the nature of the energy loss mechanisms scaling with the output power. The flexibility of the driving sixbar mechanism allows for the optimization of the architecture for particular applications and the presented model provides a means of predicting performance.